EPEVER SOLAR Cost CONTROLLER Set up: TRACER AN Sequence CONTROLLE

EPEVER SOLAR Cost CONTROLLER Set up: TRACER AN Sequence CONTROLLE

Blog Article

The EPEVER Tracer AN Collection Photo voltaic Charge Controller is usually a hugely efficient solar controller made for off-grid solar programs. According to multiphase synchronous rectification technological innovation, it makes sure optimized Electrical power conversion and system steadiness for a variety of photovoltaic (PV) apps.

Essential Functions from the EPEVER Tracer AN Sequence Controller
The Tracer AN series makes use of EPEVER Solar Charge Controller technology for top-quality photo voltaic Electricity harvesting. Critical capabilities include things like:

Multiphase Synchronous Rectification (MSR) for enhanced Strength conversion.
Innovative MPPT Algorithm with >99% efficiency.
Dual-Stage Charging for Increased battery everyday living.
Liquid crystal display Display screen with serious-time information monitoring.
Several Load Handle Modes which include guide and timer.
Thorough Electronic Protections towards overcharging, more than-discharging, short circuits, and reverse polarity.
Move-by-Action Guidebook to Starting the EPEVER Tracer AN Collection Controller
one. Unboxing and Planning the Controller
Assure all parts are incorporated: Tracer AN unit, temperature sensor, interaction cables, and user handbook.
Verify the product amount and voltage ratings match your photo voltaic panel and battery requirements.
2. Mounting the Demand Controller
Decide on a nicely-ventilated, dry location near the battery financial institution.
Secure the Tracer AN controller utilizing the offered mounting brackets.
Preserve good clearance for heat dissipation.
three. Wiring the Solar Cost Controller
Warning: Normally observe appropriate protection protocols and ensure the technique is powered off prior to connecting components.

Move 1: Connect the battery terminals to your cost controller (good to positive, destructive to detrimental).
Phase Click Here 2: Hook up the solar panel array to the PV input terminals.
Move 3: Hook up the load terminals if employing a direct load link.
Step 4: Double-Look at all connections for polarity and tightness.
4. Configuring the Controller Configurations
Electricity around the controller by connecting the battery to start with.
Make use of the Liquid crystal display display to navigate the settings menu.
Configure:
Battery Variety: AGM, GEL, Flooded, Lithium.
Charging Parameters: Absorption voltage, float voltage.
Load Handle Modes: Handbook, timer, light Regulate.
5. Monitoring and Data Logging
The Tracer AN Sequence supports actual-time monitoring using the MT50 distant meter.
Data might be logged via the RS485 conversation port using program including Photo voltaic Station Computer.
Distant monitoring is achievable with the EPEVER WiFi module.
6. Troubleshooting Popular Troubles
Issue one: No Power Output

Check out battery voltage and connections.
Validate PV panel voltage exceeds battery voltage.
Concern two: More than-Voltage Defense

Validate the solar array’s voltage score.
Regulate method parameters if important.
Problem three: No Battery Charging

Inspect PV wiring for continuity.
Ensure MPPT settings while in the menu.
Great things about the Tracer AN Series with MSR Technological innovation
The multiphase synchronous rectification technology guarantees:

Increased Performance: Reduced Strength losses during conversion.
Enhanced Dependability: Steady general performance under variable loads.
More time Battery Everyday living: Consistent and accurate charging profiles.
Conclusion
The EPEVER Solar Charge Controller with multiphase synchronous rectification technological innovation can be an Outstanding choice for optimizing solar power generation and extending battery daily life. By pursuing the above mentioned set up information, people can be certain maximum efficiency and method longevity.